Philips MICROLUX HC8900 - Manual (Page 6)

Controls
6
English
Environmental Information
All redundant packing material has been omitted.We have done our best to make the
packaging easily separable into two materials: cardboard and polyethylene
Your unit consists of materials which can be recycled if disassembled by a specialized
company. Please observe the local regulations regarding the disposal of packing
materials, exhausted batteries and old equipment.
Transmitter (figure 1)
1 Power indicator – lights up when audio
signals are detected at the audio input.
– starts blinking if the audio signals at the
input are too strong: set the input selector
switch to 3 V or reduce the audio volume
of the audio source.
2 Recharging indicator – lights up when
headphone is replaced on the
FM transmitter. Completely flat batteries
will be fully charged after about 16 hours.
3 Recharging contact – make sure you
align your headphone to this contact for
recharging.
4 DC power – connect to the 12 Volt/200
mA AC/DC adapter
5 3.5 mm stereo headphone audio
input – connects your FM transmitter to
an audio source
6 Input selector switch – select 250 mV
input if connected to a line output of an
audio source
– select 3 V input if connected to a
headphone output of an audio source
7 Channel switch – select one of
7 channels for best reception. We advise
you to select channel 1 as a first option.
8 Controls plate
Headphone (figure 2)
9 Power indication – lights up when in use.
When batteries are low, the power
indicator flashes, and you should recharge
the headphone for about 16 hours before
the next use.
10 Power On/Off – push the button to
switch the headphone on/off.
11 SRS™ indication – lights up when the
SRS™ surround sound mode is activated.
12 SRS™ On/Off – push the button to
switch the SRS™ surround sound mode
on/off.
13 Recharging contacts – align headphone
to the transmitter, green recharging LED on
the transmitter’s front must switch on,
indicating that the headphone is being
recharged.
14 Recharging indicator – lights up when
headphone is replaced on the
FM transmitter. Completely flat batteries
will be fully charged after about 16 hours.
15 Volume – adjust volume to your desired
listening level.
16 Tuning – press and hold the button for
about 1 second.The headphone
automatically tunes to the right transmission
frequency. If not, repeat this step.
XP SBC HC 8900/00-1.1 16-08-2001 15:30 Pagina 6