Philips MICROLUX HC8900 - Manual (Page 9)

3 Set the transmitter’s input selector switch
to 3 V.
4 Switch on your audio source and carefully
increase the volume of the audio source.
The red power indication LED of the
transmitter lights up if receiving an audio
signal.
5 Switch on the headphone.You may hear a
hissing sound through the headphone if the
headphone is not yet properly tuned to the
transmitter.
6 To tune, press and hold the tuning control
button for about 1 second. Repeat if
necessary.
7 Adjust the volume to the desired level with
the headphone volume control.
Basic operation
When the FM transmitter is connected to a:
- line output of an audio source, such as
REC OUT or LINE OUT or
- headphone output of an audio source.
1 Switch on your audio source and carefully
increase the volume of the audio source.
The red power indication LED of the
transmitter lights up if receiving an audio
signal.
2 If the power indication LED starts blinking:
– set the input selector switch to 3 V or
– reduce the audio volume of the audio
source.
3 Switch on the headphone.You may hear a
hissing sound through the headphone if the
headphone is not yet properly tuned to the
transmitter.
4 To tune, press and hold the tuning control
button for about 1 second. Repeat if
necessary.
5 Adjust the volume to the desired level with
the headphone volume control.
6 Push the SRS™ on/off button to switch the
SRS™ surround sound mode on or off.
Operation
9
English
XP SBC HC 8900/00-1.1 16-08-2001 15:30 Pagina 9