ProForm PFSY92080 User Manual
Page 21
Adjusting the Position of the
Press Backrest for Row Exercises
Unscrew the handle on the Adjustment Knob (99) until it
is loose. Pull out the handle as far as it will go and tilt the
Press Backrest (41) in or out to the desired position.
Release the handle and let the Knob snap into one of the
adjustment holes in the bracket on the Press Backrest
Frame (38). Tighten the handle fully.
Locking the Leg lever
For some exercises, the Leg Lever (29) must be locked in
position. To do this tighten the Locking Knob (9) located
underneath the Leg Lever into the welded nut underneath
the Butterfly Seat Frame (11).
21
Attaching the Lat Bar, Row Bar or Ankle
Strap to the Low Pulley Station
Attach the Lat Bar (61) to the Low Cable (72) with a
Cable Clip (69). For some exercises, the Chain (67)
should be attached between the Lat Bar and the Low
Cable with two Cable Clips. Adjust the length of the
Chain between the Lat Bar and the Low Cable so the
Lat Bar is in the correct starting position for the exer-
cise to be performed.
The Row Bar (70) and Ankle Strap (10) can be attached
in the same manner.
70
72
67
10
61
69
69
Adjusting the Height of the Press Seat
To adjust the height of the Press Seat (13), Unscrew the
handle on the Adjustment Knob (99) until it is loose. Pull
out the handle as far as it will go and slide the Press Seat
(13) up or down to the desired position. Release the han-
dle and let the Knob snap into one of the adjustment
holes in the Press Seat Frame (36). Tighten the handle
fully.
13
41
36
99
37
38
29
11
Bracket
Locking Knob (9)
99