Panasonic CR-W400U - Manual (Page 5)

4
Power and Sound Controls
Power
If the vehicle is not running yet, turn the key in the ignition until the
accessory indicator lights.
Press [PWR] to switch on the power.
Changing Audio Modes
Press this knob [SEL] to change the audio mode as follows.
VOL a BASS a TRE
(Volume) (Treble)
c d
FADE b BAL
(Fader) (Balance)
Volume
Press the knob to select the volume mode and then turn it
clockwise or counterclockwise to adjust the volume level.
Bass and Treble
Press the knob to select the BASS or TREBLE mode and then turn
it clockwise or counterclockwise to increase or decrease the
bass/ treble level.
0 to 40
-12 to 12 -12 to 12
Volume Level
CRW400U
Anti-Volume-Blast Circuit
At power on, the volume returns to the previous level slowly if
the level was at 20 or higher.
CRW400U
CRW400U
CRW400U
CRW400U
CRW400U
d
d