Powerware Ferrups FE/QFE 500VA - Manual (Page 7)

1 Powerware ® FERRUPS FE/QFE UPS (500 VA–18 kVA) Installation Guide
:
Rev A www.powerware.com
C H A P T E R 1
I
NTRODUCTION
The Powerware 9 FERRUPS uninterruptible power system (UPS) is
available in plug-receptacle or hardwired models. The plug-receptacle
models have an input plug and receptacles on the rear panel. The
hardwired models have terminal strips that an electrician has to wire to
AC input.
See the following sections for steps on how to use this manual for your
UPS installation.
Plug-Receptacle Installation
Only a few sections in this manual are required for installing
plug-receptacle models:
: Be sure to read all safety warnings before installing the UPS as stated
in Chapter 2, “Safety Warnings.”
: Complete Chapter 3, “Setup” for setting up the location of the UPS.
: If you purchased an external battery cabinet, an electrician must wire
the battery to the UPS as described in Chapter 7, “Battery Cabinet
Installation.”
: Continue to the startup section in the Powerware FERRUPS FE/QFE
UPS (500 VA–18kVA) User’s Guide.
Hardwired Installation
Most of the sections in this manual are required for the electrician to
install the hardwired models:
: Be sure to read all safety warnings before installing the UPS as stated
in Chapter 2, “Safety Warnings.”
: Complete Chapter 3, “Setup” for setting up the location of the UPS.
: Chapter 4, “Electrical Installation” describes the electrical
requirements for hardwiring the UPS.
: Continue to either Chapter 5, “External Bypass Switch Installation”
or Chapter 6, “Internal Bypass Switch Installation” depending on the
the type of bypass switch being installed.