Panasonic CT 30WX52 - Manual (Page 62)

62
Operating peripheral equipment using the remote control
Programming The Illuminated Remote Control Using Access Codes
The Universal Remote Control can be programmed to operate many manufacturers’ components, using the component
function buttons for VCR, DVD, AUX, RCVR, TV, DTV CABLE or DBS. Follow the procedures for programming your
Remote Control with or without a code for the component.
Determine the manufacturer of the component and look in the table for the code.
1
Confirm that the external component is plugged in and operating.
2
Turn the component off.
3
TV
DTV
CBL
AUX
DVD
VCR
DBS
RCVR
4
POWER +
A
CTION
CH
CH
VOL VOL
1 2 3
4 5 6
7 8
0
9
5
Press POWER and ACTION together, for at least 5 seconds.
After 5 seconds, all the illuminated mode keys will begin to flash.
Release the POWER and ACTION keys.
Press the mode key.
The mode key will illuminate steadily, all others will go out.
Enter the 3-digit component code using the Remote Control numeric keypad.
6
POWER
Press the Remote Control POWER to test the component. If the procedure is successful,
the component will turn on.
If the component does not operate with the Remote
Control, repeat the procedure using another code.
(Some brands have multiple codes).
If an incorrect code is entered, or if the procedure takes
longer than 30 seconds,the programming will fail.
Helpful Hints: Unsuccessful Code
Device
TV
DTV
CABLE
DBS
VCR
DVD/CD
AUX
RCVR
Operates
TV (Panasonic Only)
DTV (Panasonic Only)
CABLE (Preset)
DBS (Preset)
VCR (Preset)
DVD and CD (Preset)
Personal Video Recorders,
Tape and VCR2
Audio Receiver (Preset)
Default
Panasonic TV Codes
Panasonic DTV Codes
Panasonic CABLE Codes
Panasonic DBS Codes
Panasonic VCR Codes
Panasonic DVD Codes
Panasonic Personal Video
Recorders Code
Panasonic RCVR Code
Default Modes For Remote Control