Panasonic CT 30WX52 - Manual (Page 7)

7
Remote Control Battery Installation
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Observe the following precautions:
1. Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating the TV set.
Requires two AA batteries.
1. Turn the Transmitter face down.
Remove top cover by pressing
down on marking and sliding cover
off in the direction indicated.
2. Install the batteries as shown in
the battery compartment. (Polarity
+ or – must match the markings in
the compartment).
3. Replace the cover and slide in
reverse until the lock snaps.
Two AA size
Whenever you remove the batteries, you may need
to reset the remote control infrared codes. We
recommend that you record the code on page 64, prior
to setting up the remote control.
Helpful Hints:
For frequent remote control users, replace old batteries
with alkaline batteries for longer life.
Helpful Hints:
Note: In order to maximize the life of the batteries,
the lighted buttons on the Remote Control can be
turned OFF and ON by pressing R-TUNE and
RECALL at the same time.