Palsonic TFTV935S - Manual (Page 22)

Basic Operation
19
Select Input Source Signal
TV ------------------ select TV signal.
Video -------------- select signal from Video terminal.
S-Video ----------- select signal from S-Video terminal.
SCART1 ---------- select signal from 21-PIN SCART 1 interface.
SCART2 AV ----- select signal from 21-PIN SCART 2 interface.
SCART2 Y/C ---- select SCART 2 YC when viewing Y/C signal from 21-PIN SCART 2 interface.
YPbPr -------------
select signal from YPbPR or YCbCr terminals.
D-Sub ------------- select signal from D-Sub (I 5-pin D-sub) terminals.
HDMI -------------- select signal from HDMI/DVI terminals.
Press SOURCE to access source select menu.
Press ENTER (Up/Down) to select a desired signal source.
You may directly press the relevant number button to select a desired
signal source.
Press ENTER to confirm.
Note:
When you select to view program from SCART2 and find the colour is not properly displayed, maybe the unit is
receiving Y/C signal. To properly display the picture's colour. please select Scart2 Y/C instead of Scart2 AV
When using 21 pin Scart Converter to connect SCART2 interface on the unit with your extended devices, please
select Scart 2 AV in source select menu.
3
2
1
1. TV
2. Video
3. S-Video
4. SCART 1
5. SCART 2 AV
6. SCART 2 Y/C
7. YPbPr
8. D-Sub
9. HDMI
Select Main Source
Adjusting the Volume
Using the volume buttons (VOLUME +/-)
Press the VOLUME + or VOLUME - to increase or decrease the volume.
Muting the Sound
Using the MUTE button
At any time, you can temporarily turn off the sound using the MUTE button.
Press the MUTE button and the sound turns off.
To turn mute off, press the MUTE button again.
2
1
Changing Channels
Using the Channel Buttons (CHANNEL +/-)
Press the CHANNEL +/- to change channels.
When you press the CHANNEL +/- , the unit changes channels in sequence. You will see all the channels that the unit
has memorised.
You will not see channels that were skipped.
Direct Accessing Channels
Press the number buttons to go directly to a channel.
To select a one-digit channel:
Input the channel number by using the 0-9 number buttons directly.
To select a two-digit channel:
Press -/-- to display "- -" and input the channel number by using the 0-9 number buttons.
To select a three-digit channel:
Press -/-- to display "- - -"and input the channel number by using the 0-9 number buttons.
Note:
When you use the number buttons, You may directly select channels that were skipped.
Using the RETURN button
Press this button to switch between the current channel and the previous channel.