Precor AMT 835 User Manual
Page 23
Advertising
Assembling the AMT
21
Note: When the handlebars are mounted correctly, each
bends slightly outward.
Figure 4: View of handlebar placement
3.
Attach the handlebars using four ⁵₁₆-inch x 1¾-inch hex
head screws, eight ⁵₁₆-inch washers, and four ⁵₁₆-inch
locknuts. Using a torque wrench, tighten the fasteners
with 180 to 200 inch-pounds of torque.
Figure 5: Handlebar attachment
4.
Rotate the plastic boot so that its tab aligns with the
cutout below it, and then press the boot downward to
secure it in place.
Advertising
This manual is related to the following products: