Precor AMT 835 - Manual (Page 44)

42
Assembling and Maintaining Adaptive Motion Trainers: AMT 885 /835
Informational Displays Prior to Shutdown
The equipment saves its battery charge by moving into a
shutdown mode. If the user does not maintain the minimum
rate of motion, a 30-second shutdown process begins.
In this mode, the console displays a countdown indicator and
ignores all keypresses. If no movement is detected or the rate
of motion remains below the minimum, the indicator changes
as the countdown continues.
Note: The user can resume exercising before the countdown
period elapses and the program will continue from the point
at which it was paused.
Important: If the equipment is connected to a CSAFE master
device, it follows a slightly different shutdown process. Ten
seconds before the equipment shuts down, it ends the exercise
session and displays a reset message while it disconnects from the
CSAFE master device. It ignores all keypresses during these last
ten seconds.
Symptoms of a Low Battery
If no one has used the equipment for an extended period of
time, the battery may need recharging.
Symptoms of a low battery include the following:
 A flickering or erratic display
 Loss of user and program information after the user stops
exercising, without any display of a workout summary or a
notification of pending shutdown
Important: To maintain a constant power source, use the optional
power adapter.
Using the Optional Power Adapter
After connecting the power adapter to the equipment, plug
the opposite end into the appropriate power source (120 V or
240 V).
CAUTION: When the optional power adapter is in use, make sure
that the power supply cord does not create a safety hazard. Keep
it out of the way of traffic and moving parts. If the power supply
cord or power conversion module is damaged, it must be replaced.