Philips DVDR75/021 - Manual (Page 73)

67
Problem solving for programmed
recordings
PROBLEM SOLUTION
The DVD recorder is
not responding b While a programmed recording is being made, you cannot operate your DVD recorder manually.
If you want to cancel the programmed recording, press STANDBY
m .
' Switch off, timer
recording' flashes on
the TV screen.
b The DVD recorder was switched on several minutes before the start of a programmed recording.
Switch off the DVD recorder using STANDBY
m . A programmed recording (timer) will only
function if the DVD recorder is switched off ( STANDBY m button).
Error message: ' Insert
recordable disc'
b Either a disc has not been inserted or the disc cannot be used for recording. Insert a disc on
which recordings can be made. Switch off the DVD recorder using STANDBY
m .
The error message
'
Disc locked' appears
briefly on the screen.
b A write-protected disc has been inserted. Undo the write protection (see 'Preventing accidental
erasing of discs' in 'Manual recording') or insert a different disc.
Error message:
'
Memory full'
b If this error message appears after pressing TIMER , then all TIMER blocks are already
programmed. No more recordings can be programmed. Press the C button. If you want to clear
or check a programmed recording (TIMER block), select it with CH+ A or CH- B .
The ' Data error'
message appears on
the screen.
b The data for the recording could not be transferred. Please check date, start time and end time
of the programmed recording.
The ' Collision'
message appears on
the screen.
b Two programmed recordings overlap.
b If you ignore this error message the show with the earlier start time will be recorded first. The
start of the second show will not be recorded.
b Change the setting for either of the two recordings.
b Clear either of the two recordings
ENGLISH
Programming a recording (TIMER)