Pause and wait characters, Access your answering machine (example), Make a second call – Philips 330 User Manual
Page 68
66
Other operator services
Pause and wait characters
To obtain a pause or wait character, press and hold
#
. The display shows
w
for a wait and
p
for a pause.
The phone always interprets the first pause character as
a wait character. When you dial a number containing
a wait character, your phone dials the first part (the
phone number) and then waits for the call to be con-
nected before sending the rest of the digits as DTMF
tones. Any subsequent pause character is an ordinary
pause that generates a delay of 2.5 seconds.
Access your answering machine (example)
To hear all messages (e.g. code 3) on your answering
machine (password 8421) at phone number
12345678, you could call:
12345678w8421p3.
The phone dials 12345678 and waits for the call to be
connected. When connected, the phone transmits
8421 (the password), pauses 2.5 seconds, and then
sends the last digit. If you find that 2.5 seconds is not
long enough for your needs, you can enter several
pause characters one after the other to increase the
pause time.
You can make a second call during an active call or
during a call on hold. You can switch between the two
calls (the cost displayed on the screen depends on local
charge rate).
1.
While already on the phone, dial a number then
press
(
. The first call is put on hold and the
number is displayed at the bottom of the screen.
The second number is then dialled.
2.
To toggle between the two calls, press
,
then
select
Switch calls
. Each time that you toggle from
one call to another, the active call is placed on
hold and the call which was on hold is activated.
3.
To hang up the active line, press
)
. The active
line is hung up and the call on hold remains as
such.
4.
To end the call on hold, use
Switch calls
to reach
it, then press
)
.
Notes:
The second number can be dialled either from the key-
pad or from:
- the phonebook, by pressing
p
, then selecting the
name to be called,
- the Call list, by pressing
c
, then selecting the
number to be called.
Make a second call
Philips330_EMEA_Ind3.book Page 66 Jeudi, 31. juillet 2003 3:48 15