ParaBody 375101 - Manual (Page 15)

15
0 1 2 3 4 5 6
1/2 1/2 1/2 1/2 1/2 1/2
STEP 19
FIGURE 19
• Screw the threaded end of the PRIMARY CABLE
(33) into the end of the WEIGHT STACK SHAFT
(27) until the FLOATING PULLEY BRACKET
(11) firmly contacts the GUIDE ROD SUPPORT
(6) and the CABLE (33) slightly pulls on the
HEAD PLATE (26). Tighten the jam nut securely.
See FIGURE 19.
27
26
33
FIGURE 20
STEP 20
• SECURELY assemble two 3-1/2” PULLEYS (34) to the SWIVEL PULLEY BRACKET (13) using two 3/8 X 2” BOLTS (64), four 3/8”
WASHERS (51) and two 3/8” LOCK NUTS (50) as shown in FIGURE 20.
• Route the metal ball end of the SECONDARY CABLE (32) through the SWIVEL PULLEY BRACKET (13) as shown in FIGURE 20.
64 3/8 X 2”
51
32
50
34
32
13
CABLE ADJUSTMENT