Baxi Potterton Heatmax Combi HE Condensing Combination Boiler - Manual (Page 41)

41
14.0 Changing Components
© Baxi Heating UK Ltd 2012
Fig. 81
Cover
Burner
Gasket
Extension Piece
(not on 33 models)
Collector
Venturi
Heat
Exchanger
Rear
Insulation
Cover
Insulation
Seal
Collector
Spark
Electrode
Sensing
Electrode
Electrode
Leads
Venturi
Fig. 82
14.6 Burner (Fig. 81)
1. Undo the screws securing the collector to the cover and
venturi. On 24/28 models there is an extension piece fitted
to the cover - remove this also.
2. Withdraw the burner from the cover and replace with
the new one.
3. Examine the gasket, replacing if necessary.
4. Reassemble in reverse order.
14.7 Insulation (Fig. 82)
1. Remove the electrode leads, noting their positions. Also
remove the electrodes as described in section 14.2.
2. Undo the screws securing the collector to the venturi and
the nuts holding the cover to the heat exchanger. Draw the
collector and cover assembly away.
3. Remove the cover insulation piece.
4. Fit the new insulation carefully over the burner and align
it with the slots for the electrodes.
5. The rear insulation is retained by a screw and large
washer, remove these and draw the insulation out of the
heat exchanger.
6. Examine the cover seal and replace if necessary.