Panasonic TX-43P400X - Manual (Page 24)

24
Tuning Channels
The best tuning position is automatically
memorized.
Automatic Tune
This TV uses automatic tuning to determine whether or not the TV can receive a broadcast signal which is being sent, and
automatically prepares so that the channel selection can respond to both the position select and direct select modes.
Before Automatic Tune, Channel Select and Regional System must already be set (Refer to pages 21).
SYS SELECT
CH SELECT
AUTO TUNE
MANUAL TUNE
FINE TUNE
SKIP
SOUND SYS
COLOUR SYS
AUTO
OFF
ACCESS
POSITION
TUNING MENU
5. 5 MHz
ASIA / M.EAST
AUTO TUNE
Press to select the “AUTO TUNE”.
Press to access to the “AUTO TUNE”.
CH 29
29
SETUP : RETURN TO TUNING MENU
TV/AV : TO EXIT
AUTO SETUP IN PROGRESS
SEARCHING : PLESE WAIT
STORED CH29
Search Start.
1
When a station is found.
SOUND SYS
4.5MHz
6.5MHz
5.5MHz
6.0MHz
After all stations are tuned, the on-screen display will automatically change from “AUTO
TUNE” to “SOUND SYS” Position.
SYS SELECT
CH SELECT
AUTO TUNE
MANUAL TUNE
FINE TUNE
SKIP
SOUND SYS
COLOUR SYS AUTO
OFF
POSITION
TUNING MENU
5. 5 MHz
ASIA / M.EAST
Note:
When the sound volume is too small to confirm, turn it up by using the sound volume button on the remote control.
2
Press to improve the Sound quality, if the Sound
is not clear or no sound is produced on a
programme Number Position.
Press to exit from the Tuning Menu.
This returns the set to the normal viewing condition.
TV/AV
Press to store the Sound System.
STR
3
Under the normal viewing condition press to enter each programme Number.
Confirm the tuning condition.
If necessary, repeat step 2 for each Programme Number.
Helpful Hint
(1) If a clear picture with correct colours cannot be obtained when a Broadcast or AV signal is received, refer to the
“Colour System Selection” operation on page 28.
(2)
After the Automatic tune is finished, under the normal viewing condition press this button to
confirm the tuning condition for each Programme Number. If some Programme Numbers are
unused (no TV stations), it is possible to skip such Programme Numbers. Please refer to the
Programme Number Skip operation on page 27.