Planet Technology XRT-411 - Manual (Page 11)

Introduction
7
3. Connect WAN Cable
Connect the DSL or Cable modem to the WAN port on the Broadband Router. Use
the cable supplied with your DSL/Cable modem. If no cable was supplied, use a
standard cable.
4. Connect Printer Cable
Use a standard USB printer cable to connect your printer to the USB Printer port
on the Broadband Router.
NOTE: GDI printers are not supported. Please refer to the CD for a list of GDI
printers. You can also check with the printer manufacturer.
5. Power Up
•
Power on the Cable or DSL modem.
•
Connect the supplied power adapter to the Broadband Router and power up.
Use only the power adapter provided. Using a different one may cause hardware
damage
6. Check the LEDs
•
The PWR LED should be ON.
•
The STATUS LED should flash, then turn Off. If it stays on, there is a hardware
error.
•
For each LAN (PC) connection, the LAN LNK/ACT LED should be ON (provided
the PC is also ON.)
•
The WAN LED should be ON.
•
The USB LED should be ON.
For more information, refer to Front-mounted LEDs in Chapter 1.