ProForm PFEL19540 - Manual (Page 4)

4
M8 x 52mm Button Screw (36)—4
M4 x 16mm
Screw (52)—5
M8 Nylon
Locknut (38)—4
M10 Nylon
Locknut (33)—6
M10 Split
Washer (43)—2
M8.5
Washer (55)—2
M10 Washer
(35)—2
M8 x 25mm Button
Screw (56)—2
Pedal Arm Bolt Set (40)—2
M10 x 27mm
Button Screw (66)—2
M10 x 76mm Button Bolt (27)—2 M10 x 75mm Carriage Bolt (34)—4
M8 x 45mm Button
Screw (50)—4
M8 Split
Washer (44)—4
M8 Washer
(68)—4
Wave Washer
(29)—2
ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical trainer in a cleared area and remove the pack-
ing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included allen wrench, assembly requires a phillips screwdriver , two
adjustable wrenches , a rubber mallet , and a pair of pliers .
Use the chart below to identify the small parts used in assembly. The number in parentheses below each part is
the key number of the part, from the PART LIST on page 14. The number after the parentheses is the quantity
needed for assembly.
Note: Some parts may have been preattached for shipping. If a part is not in the
parts bag, check to see if it has been preattached.