ProForm PFEL19540 - Manual (Page 5)

5
2. While another person lifts the back of the Frame (1)
slightly, attach the Rear Stabilizer (9) to the Frame
with two M10 x 75mm Carriage Bolts (34) and two
M10 Nylon Locknuts (33).
33
1
2
34
9
33
1. Identify the Front Stabilizer (10). While another per-
son lifts the front of the Frame (1), attach the Front
Stabilizer to the Frame with two M10 x 75mm
Carriage Bolts (34) and two M10 Nylon Locknuts
(33).
Make sure that the Front Stabilizer is turned
so the Wheels (22) are not touching the floor.
1
1
10
22
22
33
34
3. The Console (23) requires three 1.5 V “AA” batteries;
alkaline batteries are recommended. Insert three bat-
teries into the battery compartment.
Make sure that
the batteries are oriented as shown by the dia-
gram inside of the battery compartment.
3
23
Batteries
4. Hold the Console (23) near the Upright (2). Insert the
console cable and the console wire down through the
Upright. Next, connect the ground wire to the Upright
with an M4 x 16mm Screw (52) as indicated. Insert
the excess wire into the Upright.
Attach the Console (23) to the Upright (2) with four
M4 x 16mm Screws (52).
Be careful to avoid
pinching the wires and cable.
2
Console Cable
Ground Wire
52
52
23
4
Console Wire
52