Setup diagram getting started – Planet Technology VRT-401G User Manual
Page 7
LAN
10/100M
ON
LAN port 100Mbps is connected
(Port 1-4)
OFF
LAN port 10Mbps is connected
LAN
LNK/ACT
ON
LAN is connected
(Port 1-4)
OFF
No LAN connection
Flashing LAN port has Activity (ACT), data being sent
WLAN
ON
Wireless LAN has been activated
OFF
Wireless LAN is disabled
Flashing
Wireless LAN has Activity (ACT) data being sent
Setup Diagram
Figure 1.2 below shows a typical setup for a Local Area Network (LAN).
Figure 1.2
Getting started
This is a step-by-step instruction on how to start using the router and get connected to the
Internet.
1) Setup your network as shown in the setup diagram above (fig 1.2).
2)
You then need to set your LAN PC clients so that it can obtain an IP address automatically.
All LAN clients require an IP address. Just like an address, it allows LAN clients to find one
another. (If you have already configured your PC to obtain an IP automatically then proceed
to step 3, page 13)
7