Panasonic DMC-LC1PP - Manual (Page 49)

Recording pictures (basic)
49
Taking Pictures Using Auto Bracket
This mode allows you to take pictures automatically according to the compensation
range of the exposure by pressing the shutter button only once.
You can select the picture with the desired exposure among different exposures.
Preparation
• Set the operational mode dial except for [
]. (P30)
1 Press [ ] until
[ AUTO BRACKET] appears on
the screen to set the
compensation range of the
exposure.
• You can select the auto bracket
from 0 (OFF), n1/3 EV, n2/3 EV
and n1 EV.
• You can set the number of the
recording to 3 or 5 by pressing 3.
¬Suggestions/Tips ¬
• The auto bracket icon appears on the
lower left of the screen.
• When taking pictures using auto
bracket after the exposure
compensation, the pictures are based
on the compensated exposure.
When the exposure is compensated,
the compensated exposure value
appears on the lower left of the
screen.
• When the flash is activated, you can
take only 1 picture. Auto bracket
setting cannot be canceled.
• When setting auto bracket, you cannot
take a picture with audio.
• When setting auto bracket and the
burst mode simultaneously, auto
bracket will be performed.
• The exposure may not be
compensated with auto bracket
depending on the brightness of the
subject.
• When setting the quality to [ ], you
cannot take pictures with the auto
bracket.
• You cannot set the number of the
recording to 5 when the picture size is
set to 2560
k1920 pixels and the
quality is set to [ ] (Super Fine).
AUTO BRACKET
FRAMES SET
REVIEW REVIEW
RAW
LC1PP.book 49 ページ ２００４年１月２６日 月曜日 午後６時５０分