Patriot Products Commercial Antenna Polar Mount - Manual (Page 12)

12
12. Assemble the Feed Plate to the inside of the Feed Struts as
shown using the 1/4” hardware also from the Feed Strut Top pack.
Then assemble the feed scalar to the dish side of the plate using the
4 slotted holes with the feed cover bottom half to the opposite side
of the plate.
NOTE: The 4 slotted holes provide skew adjustment setting
13. Check Focal Distance- 1.04m (41.04”)
Feed Cover
C-Band
Feed
Plate
(Optional 3.1m Wind Kit)
Install the Wind Kit Struts to the back of the Reflector using the supplied 1/4” hard-
ware as shown below.
2. Install the Wind Kit Struts to the back of the
Reflector using the supplied 1/4” hardware as shown
below.
Place inside of
Outboard Skirt
1. If you received a unit without a pre-drilled hub
assembly, the needed holes will need to be drilled
with a hand drill. Using a 5/16” drill, drill the 8 holes
needed along the back rim of the hub. The holes
should be equally spaced between the Radial Beam
holes, and aligned in the same bolt circle.