Panasonic AWCB400N User Manual
Page 20
20
AW-CB400
100mm
AW-RP400
AW-CB400
1
Remove the rubber caps on the side panels.
2
Use the accessory mounting screws (M4
!
8 mm) to attach the rack-mounting adaptors. Remove the rubber caps.
1
Remove the rubber caps on the side panels of the AW-CB400.
2
Attach the accessory join-up screws (stepped screws) to the two places on the side of the ROP which is to be joined to
the AW-RP400.
3
Adhere the joining stickers onto the side panels of the AW-RP400 concentrically with the join-up screws.
4
Align the
holes of the AW-CB400 with the join-up screws, shift in the direction shown by the arrow, and fit the two
units together to make a single integrated unit.
5
Attach the join-up fixture to bottom panels of the AW-RP400 and AW-CB400.
6
Attach the rack-mounting adaptors using the mounting screws (M4
!
8 mm) provided.
Rack-mounting adaptors
Join-up screws (stepped screws)
❈
When the AW-RP400 is to be joined on the left of the AW-CB400.
Accessory mounting
screws (M4
!
8 mm)
4 pcs
Mounting screws (accessory)
M4
!
8 mm ..... 4 pcs
Join-up fixture
Remove the rubber caps.
Rubber cap
Join-up screws (stepped screws)
How to mount the ROP in a rack
Joining the ROP to the AW-RP400 and mounting the joined-up units in a rack
Joining sticker
Joining sticker
<NOTE>
≥
The AW-CB400 is 100 mm wide. If it is to be installed in a full-size rack (which accommodates units totaling
420 mm in width), provide panels or other parts to supplement the AW-CB400’s width so that it will fill the
rack width-wise.
≥
If the AW-CB400 is joined to the AW-RP400, the resulting width will be equivalent to that of the full width of
the rack (which accommodates units totaling 420 mm in width).