Panasonic Generation Plasma Display Television - Manual (Page 96)

Driver Setup Adjustment
Driver Set-up
Item / Preparation
1. Input a white signal to one of the
unit’s video input.
2. Set the picture controls as follows:
Picture menu: Vivid
Normal: Set
Aspect: Full
Caution
1. Perform the Vsus adjustment.
2. Confirm the voltage level of VSCN.
This should be done after the
adjustment of Vad which should be
-105V
When Vad = -105V, Vscn voltage is 35V
±4V.
Note: See the panel label for voltages
that are not listed in the service manual.
96