Pioneer DOUBLE-DIN DVD NAVIGATION SYSTEM AVIC-D2 - Manual (Page 103)

101
Chapter
8
Cu
st
om
izing t
h
e Audio Sour
ce S
etting
AV
SUB W, you can connect a rear speaker lead
directly to a subwoofer without using an auxiliary
amp.
Initially, navigation system is set for rear full-
range speaker connection (REAR SP FULL).
When rear output is connected to full range
speakers (when REAR SP FULL is selected),
you can connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller’s (low pass filter,
phase) built-in PREOUT SUB W or the auxiliary
PREOUT FULL.
1
Touch “REAR SP” in the INITIAL menu.
2
Touch “REAR SP” to switch the rear out-
put setting.
When no subwoofer is connected to the rear
output, select FULL.
When a subwoofer is connected to the rear
output, select SUB W.
❒ When the rear output setting is SUB W,
you cannot change the subwoofer control-
ler.
3
Touch “PREOUT” to switch the sub-
woofer output or non fading output.
❒ Even if you change this setting, there is no
output unless you turn “NON FADING” or
“SUB WOOFER” in the AUDIO menu
“ON”.
➲ Using non fading output ➞ Page 99
➲ Using subwoofer output ➞ Page 99
❒ If you change the subwoofer controller
(REAR SP), the subwoofer output (SUB
WOOFER) and non fading output (NON
FADING) in the AUDIO menu return to
the factory settings.
❒ Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting.
Switching the muting/attenua-
tion
When the navigation outputs the guidance voice,
or when a mute signal has been received from
the yellow/black lead connected to the navigation
system (e.g. using a cellular telephone), the
audio volume is muted or attenuated.
This function is activated in the following condi-
tion:
— When “MUTE” or “ATT” is selected in this
setting.
— When “On” is selected in “Voice Guid-
ance” on “Mute Settings”.
➲ Mute Settings ➞ Page 63
1
Touch “TEL/GUIDE” in the INITIAL
menu.
Each touch of the “TEL/GUIDE” changes the
settings as follows:
• MUTE — Muting
• ATT — Attenuation
• NORMAL — Volume does not change
❒ The sound is turned off, “MUTE” is dis-
played and no audio adjustments are pos-
sible.
❒ The sound is attenuated, “ATT” is dis-
played and no audio adjustments, except
volume control, are possible.
❒ Operation returns to normal when the
phone connection (the mute signal on the
yellow/black lead) is ended or when the
navigation guidance is ended.
❒ Even when you receive a phone call, navi-
gation voice guidance cannot be attenu-
ated or muted. Use the Volume to control
the navigation voice guidance volume.
Initia
l Settings