Precor CW34864-101 - Manual (Page 19)

Experience Strength™ C-Line Owner’s Manual: Monthly Inspection 16
Lubricate Pop Pins
Pull out the pop pin as far as it goes and apply a small amount of silicone
spray lubricant. Wipe off any excess lubricant with a cloth. (Refer to the
following figure.)
CAUTION: Pulling out the pop pin may cause the unit to adjust position
suddenly. To avoid injury, keep your hands and head away from moving parts.
Test the pop pin for proper function and engagement in each adjustment
hole.
Figure 9: Lubricate the pop pin by pulling it out
Inspect All Fasteners
Fasteners can loosen with normal use. Inspect all nuts, bolts, screws, and
other fasteners to make sure they are tight and installed correctly.
Be sure to check fasteners at bolted joints to make sure the connections are
secure. If a fastener is loose but in good condition, retighten it. If you are
concerned about the integrity of the fastener, remove it, clean the threads,
and inspect it for any damage such as cracks, bad threads, corrosion, or rust.
Reinstall the fastener if it appears to be in good condition. Otherwise, remove
the equipment from service until a new fastener can be installed properly.
You can order new fasteners from Customer Support. For additional
information, refer to
Obtaining Service .