Philips DVD707/781 - Manual (Page 11)

12
English
MAINS
MAINS
Receiver
MAINS
Connection
Audio connection
Connect Audio output to TV
¶ To use the TV speaker for sound reproduction, connect the audio left
and right outputs on the rear panel of the player to the corresponding
inputs on your TV with the audio cable supplied.
Connecting to an A/V receiver equipment
Digital multi-channel connection provides the best sound quality. For this
you need a multi-channel receiver that supports one or more of the
audio formats supplied by your DVD player (Dolby Digital
TM , MPEG 2
and DTS). Check the receiver manual and the logos on the front of the
receiver.
Connect to A/V receiver with digital coaxial cable
¶ Connect the player’s digital coaxial output to the corresponding input on
the receiver using the normal audio or video cable which is supplied.
¶ You will need to set the item [AUDIO] in setup menu for adapting your
receiver. Please refer to the chapter [Setup Menu] for details.
¶ In this case, do not use the player’s audio left and right output.
NOTE:
– If the audio format of the digital output does not match the capabilities of
your receiver, the sound will be muted.
Analog connection to a multi-channel A/V receiver with 6CH
connectors
¶ This DVD player contains a multi-channel decoder. Connect the audio
outputs to the corresponding inputs of your A/V receiver with six audio
cables. In the Audio output menu, set Analog output to 6 Channels
model. (please refer to setup menu in page 22 for details.)