PLUS Vision U5-632h - Manual (Page 12)

E-12
Names of the Remote Control Parts/Preparing the Remote Control
Names of the Remote Control Parts
Names of Parts/Preparing the Remote Control Unit
Included with the U5-532h and U5-512h Applicable Projector:
U5-532h/U5-512h
Button Battery Replacement
Using the remote control for the first time
The battery compartment is fitted with a transportation insulation sheet at the time of shipping. Pull out
the sheet and remove it. The remote control is now ready for use.
1. Infrared transmitter [E-12]
2. STANDBY button [E-23, 25]
This button is used to switch ON the power
and set the unit to the STANDBY mode.
3. Buttons used for input selection
[E-28]
RGB button and VIDEO button (VIDEO /
S-VIDEO)
4. MUTE button [E-30]
(Temporarily cancels the video and audio)
5. Number buttons [E-37]
(Used for the security lock.)
6. FREEZE button [E-30]
(Freezes moving pictures)
7. VOL button [E-31]
(Volume adjustment)
8. KSTN button [E-31]
(Keystone correction adjustment)
RGB
VIDEO
FREEZE MUTE ECO AUTO
ASPECT
TIMER VOL KSTN ZOOM
CANCEL QUICK
MENU
ENTER
Q
STANDBY
1 2 3 4
1
2 9
10
11
12
13
14
15
3
4
5
6
7
8
9. Buttons used for menu operations
[E-40]
The
, , and buttons are the
select ( ̆, ̄, ̇ and ̈) buttons.
10. QUICK button [E-39]
(Displays a simplified menu)
11. ECO button [E-30]
(Selection of lamp mode)
12. AUTO button [E-28]
(Automatic adjustment of the RGB moving
image)
13. ASPECT button [E-29]
(Selects the vertical and horizontal ratio of
the screen)
14. TIMER button [E-33]
(Presentation timer time setting display)
15. ZOOM button [E-32]
(Digital zoom adjustment)
Replacement Method
(B)
(A)
CR2025 CR2025
CR2025
Purchase a CR2025 type battery for replacement.
3 Insert the battery holder into the
remote control and push in until
the battery holder closes with a
“click” sound. 2 Remove the old battery and install
a new button battery with (+) side
facing upward in the battery
holder. 1 (A) With the knob pressed to the
right side, (B) draw out the battery
case.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type (CR2025) recommended by the manufacturer.
Dispose of used batteries according to your local regulations.
Remote Control Range
Point the infrared transmitter of the remote control toward the remote control sensor located at the front or rear of the main unit
and operate. Reception of the remote control signal should generally be possible within the range illustrated below.
Note
* Exposure of the main unit’s remote control sensor or the remote control infrared transmitter to bright light or the obstruction of the signal
by an obstacle located in the pathway may prevent operation.
* The remote control will not function when the battery is exhausted.
Applicable Projector: U5-532h/U5-512h Applicable Projector: U5-632h/U5-732h
5m/16.4feet
5 ° 5 °
6
m/19.7
feet
20 °
20 °
3m/9.8
feet
5m/16.4feet
30 °
30 °
3m/9.8
feet
5 ° 5 °
6
m/19.7
feet
Side View Top View
Remote control
infrared transmitter
Remote control sensor Remote control sensor
Side View Top View
Remote control sensor
Remote control
infrared transmitter
Remote control infrared transmitter Remote control infrared transmitter
Remote control sensor