PLUS Vision U5-632h - Manual (Page 25)

E-25
Power Cable Connections and Switching the Power On/Off
Finishing
Warrning
Do not unplug the power cable while the STANDBY indicator is flashing amber. Doing so may shorten the life of the lamp
or damage the projector.
1
Switch off the power of the connected equipment
RGB
STANDBY
VIDEO
FREEZE MUTE ECO AUTO
ASPECT
CANCEL QUICK
MENU
ENTER
Q
1 2 3 4
LASER
AUTO RGB VIDEO
QUICK MENU
Q
STANDBY
2
Switch off the power of the projector
Press the STANDBY button.
The [Power Off] display appears.
When the level gauge reaches maximum, the projection screen
will go off (in about 5 seconds) and the projector will enter the
power-off operation.
Note
* The operation can be cancelled by pressing a button other than
the STANDBY button.
* One more press of the STANDBY button will switch off the power.
The STANDBY indicator changes to flashing amber and lights a
steady amber after about 90 seconds (when the unit enters the
standby mode).
Flashing amber
(Approximately 90
seconds)
Lit amber
Standby mode
STANDBY
STATUS
STANDBY
STATUS
STANDBY
STATUS
Lit green
3
Unplug the power cable
Check that the STANDBY indicator is lit in amber and then unplug the power cable.
The STANDBY indicator will go off when the power cable is unplugged.
Power Off
OK ?
STANDBY (button on main unit)