Pioneer DVR-660H-S - Manual (Page 20)

Connections 02
20
En
1 Connect RF antenna cables as shown.
This enables you to watch and record TV
channels.
2 Connect the AUDIO and VIDEO
OUTPUT jacks (1 or 2) on this recorder to
a set of audio/video inputs on your AV
amp/receiver.
3 Use an coaxial digital audio cable (not
supplied) to connect the DIGITAL AUDIO
OUT (COAXIAL) jack on this recorder to
an coaxial digital input on your AV amp/
receiver.
This enables you to listen to multichannel
surround sound.
1
4 Connect the AV amp/receiver’s video
output to a video input on your TV.
Connecting using HDMI
If you have an HDMI or DVI-equipped 2
monitor or display 3 , you can connect it to
this recorder using an HDMI cable 4 (not
supplied).
The HDMI connector outputs uncompressed
digital video, as well as almost every kind of
digital audio.
1 Use an HDMI cable to connect the
HDMI OUT connector on this recorder to
an HDMI connector on an
HDMI-compatible display.
• The arrow on the cable connector body
should be face down for correct
alignment with the connector on the
recorder.
When connected to an HDMI component or
HDCP-compatible DVI component, the
HDMI indicator lights.
HDMI setup is generally automatic. There
are however settings you can change if you
need to. See HDMI Output (only available
when an HDMI device is connected) on
page 117 for more information. Note that the
Note
1 If your AV amp/receiver doesn’t have an coaxial digital input, but has a optical type, converter boxes that convert
from coaxial to optical are available at specialist audio dealers.
AC IN CONTROL
IN
S-VIDEO VIDEO AUDIO L R
ANTENNA
IN
OUT
S-VIDEO
VIDEO AUDIO L R
Y P B P R OUTPUT 1
OUTPUT 2
COMPONENT VIDEO OUT INPUT 1 /AUTO START REC
INPUT 3 COAXIAL
HDMI OUT DIGITAL OUT
1
1
3
2
4
Antenna/cable TV
wall outlet
ANTENNA
IN (RF IN)
ANTENNA
OUT
DIGITAL
AUDIO OUT
To audio/
video input
OUTPUT 1
AV amp/receiver
To digital input
To video input
TV
From video
output
To antenna
input
2 Depending on the component you have connected, using a DVI connection may result in unreliable signal
transfers.
3 The pixel resolution of this recorder’s HDMI video output is (according to TV format): NTSC (720 x 480i/p,
1280 x 720p, 1920 x 1080i/p) and PAL (720 x 576i/p, 1280 x 720p, 1920 x 1080i/p). If your display is not compatible
with these resolutions the picture may not be correctly reproduced.
4 The 1080p video may not be displayed correctly if the High Speed HDMI cable is not used.
AC IN
CONTROL
IN
S-VIDEO VIDEO AUDIO L R
ANTENNA
IN
OUT
S-VIDEO
VIDEO AUDIO L R
Y P B P R OUTPUT 1
OUTPUT 2
COMPONENT VIDEO OUT INPUT 1 /AUTO START REC
INPUT 3 COAXIAL
HDMI OUT DIGITAL OUT
HDMI
IN
HDMI-compatible display
HDMI
OUT
To HDMI
input
DVR660HS_TLT_EN.book 20 ページ ２００８年２月２０日 水曜日 午前１１時３３分