Philips IPLAYER 3 - Manual (Page 3)

Light Show Playback
Out-of-the-box, the iPlayer 3 comes programmed with preconfigured light shows. When you start up the
iPlayer 3, it automatically plays the default color wash show assigned to preset button .
To play additional shows, press – .
To adjust the overall brightness level of your show, press and .
Press to pause playback and turn all fixtures OFF.
D Note
You can change the preconfigured show assigned to each preset button (see for details). You can
also download and assign custom ColorPlay 3 shows to the preset buttons (see
ColorPlay 3 User Guide ).
•
•
•





'DA






36/
.0%&
4GNV
































=
#
















Understanding Light Addresses
E Tip
To follow this Quick Start guide, do not change the default light addresses assigned to your fixtures.
iPlayer 3 streams data to the RGB lighting fixtures in your installation via the DMX512 protocol.
Each fixture in your installation has a light address. For light show designs with the same color displayed
simultaneously on all fixtures, changes to the factory default light addresses are not necessary. However, if
the light show design specifies different colors on different fixtures, then you must re-configure each fixture
with a unique light address.
Most non-Chromasic fixtures come pre-addressed to light address 1. Use the iPlayer 3 SAS (Serial
Addressing Software) tool to manually re-address your fixtures, as needed. iPlayer 3 SAS is available for
download here: www.colorkinetics.com/support/downloads/
Chromasic ® fixtures are addressed to light address 1 through light address n, the number of nodes per
fixture. If a starting address different from 1 is required, use the iPlayer 3 SAS tool to enter a base address
for the first node, and the remaining nodes will address automatically in sequential order.
Hardware Installation
The iPlayer 3 comes packaged with the printed iPlayer 3 Installation Instructions. The Installation Instructions
document has illustrated steps covering physical setup, hardware mounting, and connecting your lighting
system. Follow the steps in the iPlayer 3 Installation Instructions now.
Adjust brightness level
Change mode
Navigate menus
Pause / resume show
Cancel menu action
Select a show trigger for playback