Panasonic CF-Y7 - Manual (Page 22)

22
Get
ting St
arted
U
seful In
formati
on
Troubleshooting
Appendix
Hard Disk Backup Function (Recover Pro)
The Recover Pro creates a backup area (storage area) on the hard disk to back up (store) the hard disk data, and
restores the backup data to its original location when it is lost or corrupted by operational errors or other factors.
You do not need external media or peripheral devices to back up or restore hard disk data on this computer.
At purchase, the Recover Pro is not installed. Install using the instructions below.
The Recover Pro provides 3 types of backup as follows:
Quick Backup: Scheduled backup of the updated data
File Backup: File backup at file save and change
Complete Backup: Backup of the entire data on the internal hard disk
Here, we will explain the procedures for installation, complete backup (backing up hard disk contents in case Windows
cannot be booted), and complete restore (recovering the hard disk data to its condition at the time of the complete
backup).
For further information, refer to the software’s online manual (
page 23).
CAUTION
All operations should be executed with the AC adaptor connected. Do not turn the power off while operations are in
progress. If the power is turned off while installation, backup, or restore operations are in progress, these operations
may not function properly, and it may be impossible to start Windows. Also, do not press any keys or slide any
switches, including hot keys.
When restarting the computer, the message “Check file system on C:” will appear. Follow the on-screen instructions.
Do not skip the check process.
Make sure you allow enough space on the hard disk when choosing settings during installation. To change these
settings you must reinstall Recover Pro.
To execute Complete Backup reliably, we recommend performing [Typical] installation in the following cases.
• Hard disk with a single partition
• Immediately after reinstalling software (when more than half of the entire space of the hard disk is available)
( page 25)
Be sure to use the internal hard disk drive to create the backup area. Never use disk or device other than the internal
hard disk drive.
Some software (security software, backup software, encryption software, or hard disk accessible specific software,
etc.) may be incompatible with Recover Pro.
For further information, refer to:
http://www.phoenix.com/en/Customer+Services/White+Papers-Specs/Recover+Pro/default.htm
When using Personal Secure Drive ( Installation Manual of "Trusted Platform Module (TPM)"), do not execute
File Backup for Personal Secure Drive.
The “Create recovery CD-DVD” function in Recover Pro is designed to help you save complete backup data to CD or
DVD. When using the “Create recovery CD-DVD”, you can view the complete backup data on the hard disk, but take
care to avoid accidentally deleting this data.
Preparation
Connect the AC adaptor.
1 Log on to Windows as an administrator.
2 Close all programs.
3 Disable anti-virus software.
4 Click [start] - [Run], enter [c:\util\rcvpro\setup.exe], and click [OK].
The InstallShield Wizard screen appears.
5 Click [Next].
Follow the on-screen instructions.
Carefully read the License Agreement, and click [I accept the agreement.].
The computer restarts several times to complete installation. appears in the notification area.
The Recover Pro cannot back up or restore data correctly if a hard disk problem occurs during data backup or restoring.
If an error occurs due to an unexpected malfunction, incorrect operation, or other reason while data is being
restored, the hard disk data (data before restoration) may be lost.
Matsushita Electric Industrial Co., Ltd. will bear no responsibility for any damage suffered (including loss of data) as a
result of the use of this function.
Installation