Panasonic AJ-HDC27A - Manual (Page 24)

24
Using an AC power supply
When the AJ-B75 AC adapter is used
<Notes>
O
Check the pin signals of the EXT DC IN socket
when using an external power supply other than the
AJ-B75 AC adapter. (DC 12 V, 8.5 A)
O
Power from the AC adapter takes precedence when
both a battery pack and AC adapter have been
connected.
O
When using the AC adapter, be absolutely sure to
first set the power of the AC adapter to ON and
then set the unit’s power switch to ON.
If the power is turned on in the reverse sequence,
the output voltage of the AC adapter will rise
gradually, and the unit may malfunction as a result.
1
2
3
4
1
Connect the DC OUT connector on the AJ-B75 AC
adapter to the EXT DC IN socket on the unit.
EXT DC IN socket
2
Set the power of the AC adapter to ON.
3
Set the unit’s power switch to ON.
Pin no. Signal
1 GND
2, 3
==
4 +12 V
Power supply
<Notes>
O
Before connecting or disconnecting the plug, be
absolutely sure to turn off the unit’s power.
O
When attaching the battery case or holder, take
care not to pinch the connecting cord.
Using the Sony BP-L60/L90 lithium-
ion battery
1
Attach the accessory battery mounting connector.
(Refer to the previous page.)
2
Attach the battery holder for the lithium-ion battery.
1. As shown in the figure, detach the battery
clamp, and attach the holder using the mounting
screws.
2. Tighten the power contact screws.
3. Attach the battery clamp.
Battery clamp