Panasonic AJ-HDC27A - Manual (Page 63)

63
6
Turn the JOG dial button to move the arrow
(cursor) to YES, and press the JOG dial button.
When the data loading is completed, the following
message appears.
To load the VTR unit’s data, open the VTR CARD
READ/WRITE screen, and perform steps
4 to 6 .
< CAM CARD READ/WRITE >
READ
SELECT :1
WRITE
SELECT :1
CARD CONFIG
READ USER DATA
TITLE :
READ OK
YES
n NO
TITLE :
If one of the following messages appears when the JOG dial
button is pressed, the data cannot be loaded.
7
Press the MENU button to exit the menu
operations.
The setting menu is cleared, and the display
showing the unit’s current statuses appears at the
top and bottom of the viewfinder screen.
Error message Remedial action
READ NG
NO CARD
(setup card has not been
inserted) Insert the card.
READ NG
FORMAT ERROR
(formatting error) The card was formatted by a
device other than the unit.
Replace the card.
READ NG
NO FILE
(file not found) Save the file data.
READ NG
ERROR
(the data cannot be loaded) Data saved by devices other than
unit cannot be loaded.
Loading the data saved on the
card
Setup card operations
Select the file No.
Load the data of the selected file.
1
Perform the menu operations (pages 70 to 72),
and display the “CAM CARD READ/WRITE”
screen.
n < CAM CARD READ/WRITE >
SELECT :1
READ
SELECT :1
WRITE
CARD CONFIG
READ USER DATA
TITLE :
2
Turn the JOG dial button to move the arrow
(cursor) to the SELECT item which comes after
READ, and press the JOG dial button.
3
Turn the JOG dial button to select any number
from 1 to 8, and press the JOG dial button.
4
Turn the JOG dial button to move the arrow
(cursor) to the READ item.
< CAM CARD READ/WRITE >
SELECT :1
n READ
SELECT :1
WRITE
CARD CONFIG
READ USER DATA
TITLE :
5
When the JOG dial button is pressed, the following
message appears.
< CAM CARD READ/WRITE >
READ
SELECT :1
WRITE
SELECT :1
CARD CONFIG
READ USER DATA
TITLE :
READ ?
YES
n NO
TITLE :
< CAM CARD READ/WRITE >
n SELECT :1
READ
SELECT :1
WRITE
CARD CONFIG
READ USER DATA
TITLE :