Pioneer KEH-P7020R - Manual (Page 29)

07
Section
Multi-CD Player Audio Adjustments
En 29
English
Español
Deutsch
F
rançais
Italiano
Nederlands
Using compression and bass
emphasis
You can use these functions only with a multi-CD
player that supports them.
Using COMP (compression) and DBE (dynamic
bass emphasis) functions let you adjust the
sound playback quality of the multi-CD player.
Each of the functions have a two-step adjust-
ment. The COMP function balances the output
of louder and softer sounds at higher volumes.
DBE boosts bass levels to give playback a fuller
sound. Listen to each of the effects as you select
through them and use the one that best
enhances the playback of the track or CD that
you are listening to.
1 Press FUNCTION to select COMP .
Press FUNCTION until Comp/DBE appears in
the display.
• If the multi-CD player does not support
COMP/DBE,
No Comp is displayed when you
attempt to select it.
2 Press
5 or ∞ to select your favorite setting.
Press
5 or ∞ repeatedly to switch between the
following settings:
Comp OFF — Comp 1 — Comp 2 — Comp OFF —
DBE 1 — DBE 2
Introduction of audio
adjustments
1
AUDIO display
Shows the audio adjustments status.
Press AUDIO to display the audio function
names.
Press
AUDIO repeatedly to switch between the
following audio functions:
Fad (balance adjustment)— EQ (equalizer curve
adjustment)— Bass (bass)— Treble (treble)—
Loud (loudness)— Sub-W1 (subwoofer1)/ Non Fad
(non fading output on/off)— Sub-W2
(subwoofer2)/ Non Fad (non fading output set-
ting)— HPF (high pass filter)— SLA (source level
adjustment)— ASL (automatic sound levelizer)
• When the subwoofer controller setting is only
S.W Control:EXT , you cannot switch the Sub-W1 .
(Refer to page 38.)
• You can select the
Sub-W2 only when
Subwoofer output is switched on in the Sub-W1 .
• When the subwoofer controller setting is only
S.W Control:EXT , you can switch the non fading
output on/off mode. (Refer to page 38.)
• You can select the non fading output setting
mode only when non fading output is switched
on in the non fading output on/off mode.
• When selecting the FM tuner as the source,
you cannot switch to
SLA .
• To return to the playback display, press
BAND/ESC .
1