Philips MX3910D/37 - Manual (Page 23)

21
English
Getting Started
Setting the speakers’ channels
You can adjust the delay times (center and
surround only) and volume level for
individual speakers. These adjustments let
you optimize the sound according to your
surroundings and setup. Speaker settings are
only active on Multi-channel audio outputs.
Personal setting ...
Set Speaker Settings
Digital Output
Analog Output
Night mode
Speaker Layout
Speakers
PCM Output Front L & R
Center
Surr L & R
Sub Woofer
OK to exit
3 dB 6 dB On 3 ms
1
Press SURR. (or SURROUND on the
front panel) repeatedly to select ‘Multi-
channel’.
2
In disc mode, press SYSTEM MENU.
3
Use the joystick (1 2 3 4) on the
remote to navigate in the menu.
4
Select icon and press 4.
Move to and press 2.
Move to {Speakers} and press 2.
5
Press 3 4 to select ({Front L&R},
{Center}, {Surr L&R}, {Sub Woofer}), then
press 2 to enter the speaker setting menu.
➜
The test tone will be automatically
generated.
6
Use 3 4 to adjust the settings for each
speaker to suit your surround sound
needs. These adjustments may include :
A Turning on or off the sound output.
B Delay time settings - use the longer
delay settings when the surround
speakers are closer to the listener than
the front speakers.
C Adjusting the volume levels for one or
both speakers until the sound evens.
7
Press OK to confirm.
To remove the menu
Press SYSTEM MENU.
Step 5: Setting language
preferences
You can select your preferred language
settings so that this DVD system will
automatically switch to the language for you
whenever you load a disc. If the language
selected is not available on the disc, the
disc’s default setting language will be used
instead. Except the DVD system’s Menu
Language, it will remain once selected.
SETUP MENU
➠
English
Français
Parental
Password
Defaults
Menu Language
Audio
Subtitle
Disc Menu
English
English
English
Go to language setup page
1
In disc mode, stop playback and press
SYSTEM MENU.
2
Use the joystick (1 2 3 4) on the
remote to navigate in the menu.
3
Select icon and press 4.
Move to and press 2.
Move to {Menu Language} and press 2.
4
Select a language and press OK.
5
Use the joystick (1 2 3 4) on the
remote to navigate in the menu.
Move to and press 2.
Move to one of the following and press 2.
– {Audio Language} (disc’s soundtrack)
– {Subtitle} (disc’s subtitles)
– {Disc Menu} (disc’s menu)
6
Select a language and press OK.
7
Repeat steps
5
~
6
for other settings.
To remove the menu
Press SYSTEM MENU.
A B C