Panasonic SC-HT07 EN - Manual (Page 4)

4
RQT7
38
4
Spea
ker
se
tup (for
SC
-H
T07
)
Step 1
1
Speaker setup (for SC-HT07)
Step
• To prevent damage or scratches, lay a soft cloth and perform assembly on it.
• For assembly, use a Phillips-head screwdriver.
Front and surround speaker assembly
1
1
2
3
Attach the pipe to the bases.
Thread the speaker cable through the base.
Thread the speaker cable through here. Groove
Insert the pipe.
Insert the pipe while
slightly pulling on the
speaker cable.
Secure the pipe to the base.
Ensure the screws are securely fastened by lightly tightening
the left and right side screws alternately until fully tightened.
(The heads of the screws protrude slightly even if you have
fully tightened them.)
The supplied stands are specially designed for
attachment to Panasonic SB-FS927 front speakers
and surround speakers.
Only use as indicated in this setup.
Large screws
(included)
2
1
Attach the stand to the speaker.
Ensure the stand is fastened on straight by lightly
tightening the top and bottom screws alternately
until fully tightened.
• There is no difference between the right and left
speakers and stands.
You can also attach to the upper rear of the speaker.
When attached to the upper rear, you can adjust the height of the speakers between 625 mm and 796 mm. When attached to the
lower rear, you can adjust the height of the speakers between 968 mm and 1138 mm.
(Speaker height adjustment
è procedure 3)
For your reference
You can enjoy good acoustics by
adjusting the height of the front
speaker with the height of the
television so the center positions
of both are approximately the
same.
It is usually better to make the
surround speakers a little higher.
Small screws
(included)
SC-HT07EB-EN.fm Page 4 Friday, May 7, 2004 4:29 PM