Philips VL1100 User Manual
Page 10
Additional features
Using the remote control blaster cord
If the video source does not respond to remote control commands, the
remote control blaster cord should be connected.
1 Ensure that the transmitter unit is switched off.
2 Connect the blaster cord to the IR connector (7) of the transmitter
unit.
3 Locate the position of the IR sensor on the video source.
Normally it is located on the front panel, positioned to the left or right
of the display. (See the User Manual of your VCR, DVD or SAT box.)
4 Remove the adhesive tape from the IR light and fix the IR light on the
IR sensor of the video source.
Notes:
– Placing the IR light 5-10 cm in front of the video source instead of precisely
on the device makes finding the exact location less critical.
– Particular brands and types of TV react to remote control signals by making a
buzzing noise when a command is given.
– If you are still having problems getting your configuration to work correctly,
check ‘Problem solving’.
– It is possible to control devices of most brands, but some devices from Sagem,
Nokia and Bang & Olufsen cannot be controlled remotely.
ENGLISH
10
IR SENSOR
SBC VL1100 TVLINK TRANSMITTER
SBC VL1100 TVLINK TRANSMITTER
VCR
VCR
1 2 3 4
1 2 3 4
AV SOURCE INPUT
R–AUDIO–L
CHANNEL
IR
VIDEO
DC 9V
AV SOURCE INPUT
R–AUDIO–L
CHANNEL
IR
VIDEO
DC 9V
SCART OUTPUT
SCART OUTPUT
XP SBC VL1100 07-02-2003 12:48 Pagina 10