Pyramid Car Audio PR530A - Manual (Page 5)

4
PANEL INFORMATION
PRESET EQ EXTERNAL
PROCESSOR PHONO VIDEO CD TUNER AUX TAPE
BALANCE
TREBLE BASS
-10 -10 10+ 10+
2 2 2 2
0 0
8 8 8 8
4 4 4 4
6 6 6 6
L R
ON / STANDBY
Down
MASTER VOLUME
-58 dB VOLUME LEVEL -48 dB -38 dB -28 dB -18 dB -8 dB -0 dB
Up
VOL MIC 1 MIC 1 MUTE
PHONES
VOLUME LEVEL
DISPLAY
STEREO HIGH-FIDELITY AMPLIFIER PA-3035
POWER
MULTI-FUNCTION REMOTE CONTROLLED SYSTEM
- dB oo
1 18 9 2 4 16 15 6
5 3 8 7 10 11 12 13 17 20 19 14
1. POWER SWITCH
Power is supplied to the amplifier when pressing this
switch once and the power is switched off if pressing once
more.
2. INDICATOR DISPLAY
Press either PHONO, TUNER, CD, TAPE, VIDEO or
AUX, the relative indicator will be grown.
3. PRESET EQ
Press this switch to preset one of the following kinds of
music: POP (green color), ROCK (red color), CLASSIC
(orange color) and FLAT (no color).
4. MASTER VOLUME
This is used to control the sound heard from the speakers
or through the headphones. The volume will be increased
when rotates the volume clockwise.
5. EXTERNAL PROCESSOR
When this unit is connected to an external graphic
equalizer or sound processor, press this switch.
6. BALANCE VOLUME (L/R)
The volume of the left and right speakers can be adjusted
by the BALANCE volume. As the volume is turned to left,
the sound from the left speaker becomes louder than that
from the right speaker, and vice versa.
Adjust so that the sounds from the left and right speakers
are heard with equal volume at your listening position.
7. MIC LEVEL VOLUME
Adjust the MIC LEVEL by rotating MIC LEVEL
VOLUME knob. (just for karaoke only)
8. MIC JACK
Inserting Microphone if using. (just for karaoke only)
9. REMOTE SENSOR
Work with the remote control.
10. VIDEO/AUX
This switch is pressed when using the component
connected to the VIDEO/AUX terminals for playback.
11. TAPE
This switch is pressed when you wish to listen to the
cassette deck connected to the tape terminals.
12. CD
This switch is pressed when you wish to listen to the
compact disc player connected to the CD terminals.
13. TUNER
This switch is pressed when you wish to listen to the radio
broadcasts from the tuner connected to the TUNER
terminals.
14. PHONO
This switch is pressed when you wish to listen to records
on the turntable connected to the PHONO terminals.
When the power of the unit is turned on the initial
position of input selector switch is set to “TUNER”.
Be sure to press the desired switch (one only) firmly.
15. TONE CONTROL TREBLE VOLUME
The treble sound is emphasized when the TREBLE knob is
rotated clockwise from its “0” position while it is
attenuated when the knob is rotated counterclockwise.
16. TONE CONTROL BASS VOLUME
The bass sound is emphasized when the BASS knob is
rotated clockwise from its “0” position while it is
attenuated when the knob is rotated counterclockwise.
17. PHONES JACK
This is the jack for the headphones. Connect the plug on
the stereo headphones for private listening.
Adjust the volume so that it does not hurt your ears when
using the headphones.
- If you do not intend to use your headphones, always
ensure that you unplug them.
18. REMOTE STANDBY INDICATOR
The Power Amplifier is in remote standby state if the
remote standby indicator is lighted.
19. MUTE
Press this switch to mute the sound, press it again to cancel
the mute function.
20. VOLUME LEVEL DISPLAY
Press this switch to see the volume level indicated by
INDICATOR DISPLAY.