Porter-Cable MCM155 - Manual (Page 11)

10
Connect power
Caution
Risk of product damage! Ensure that the power supply •
voltage corresponds to the voltage printed on the back
or the underside of the Micro Hi-Fi.
The Micro Hi-Fi is equipped with a voltage selector on
•
the back panel. It is preset at 220V from the factory.
For areas that operate at 110V-127V, adjust the voltage
selector to 110V-127V before connecting the AC
power supply.
Before connecting the AC power cord, ensure you have
•
completed all other connections.
Note
The type plate is located on the back of the main unit. •
1
Connect the AC power cord to the wall
socket.
3 Connect
Connect speakers
Note
Insert the stripped portion of each speaker wire into •
the socket completely.
For optimal sound, use the supplied speakers only.
•
Connect only speakers with impedance that is the •
same or higher than the supplied speakers. Refer to the
Specifi cations section of this manual.
1
For the right speaker, fi nd the sockets on
the main unit marked ‘RIGHT’.
2
Insert the red wire to the red (+) socket.
To insert each speaker wire:
a Hold down the socket fl ap.
b Insert the speaker wire fully.
c Release the socket fl ap.
3
Insert the black wire into the black (-)
socket.
4
For the left speaker, fi nd the sockets on the
main unit marked ‘LEFT’.
5
Repeat steps 2-3.
EN
MCM166_55_EN.indd Sec1:10 MCM166_55_EN.indd Sec1:10 2/11/2009 11:25:45 AM 2/11/2009 11:25:45 AM