Porter-Cable MCM155 - Manual (Page 17)

16
2
Press PROG to activate program mode.
[PROG] (program) blinks on the »
display.
3
Press ALB/PRESET+/- to allocate a
number to this radio station, then press
PROG to confi rm.
The preset number and the frequency »
of the preset station are displayed.
4
Repeat the above steps to program other
stations.
Tip
To overwrite a programmed station, store another •
station in its place.
Select a preset radio station
1
In tuner mode, press ALB/PRESET+/- to
select a preset number.
Tip
Position the antenna as far as possible from TV, VCR or •
other radiation source.
For optimal reception, fully extend and adjust the
•
position of the antenna.
Change AM tuning grid
In some countries, the AM radio frequency step
between adjacent channels is 9 kHz (10 kHz in
some areas).
1
Select the tuner source.
2
Press and hold on the main unit for
more than 5 seconds.
The frequency step is changed to 9 »
kHz or 10 kHz.
All preset stations are erased and need
»
to be re-programmed.
8 Listen to radio
Tune to a radio station
1
Press TUN repeatedly to select FM or AM.
2
Press and hold / for more than 2
seconds.
[SEARCH] (search) is displayed. »
The radio tunes to a station with »
strong reception automatically.
3
Repeat step 2 to tune to more stations.
To tune to a weak station, press • /
repeatedly until you fi nd optimal
reception.
Program radio stations
automatically
You can program a maximum of 40 preset
radio stations.
1
In the tuner mode, press and hold PROG
for 2 seconds to activate automatic
program mode.
[AUTO] (auto) is displayed. »
All available stations are programmed »
in the order of waveband reception
strength.
The fi rst programmed radio station is
»
broadcast automatically.
Program radio stations
manually
You can program a maximum of 40 preset
radio stations.
1
Tune to a radio station. (See “Tune to a
radio station” on page 16 ) .
EN
MCM166_55_EN.indd Sec1:16 MCM166_55_EN.indd Sec1:16 2/11/2009 11:25:48 AM 2/11/2009 11:25:48 AM