Panasonic KX-FLB756 - Manual (Page 81)

81
FCC Information
List of FCC requirements and information !
This equipment complies with Part 68 of the FCC rules and
the requirements adopted by the ACTA. On the rear of this
equipment is a label that contains, among other information,
a product identifier in the format US:ACJ----------.
If requested, this number must be provided to the telephone
company.
• Registration No .....................(found on the rear of the unit)
• Ringer Equivalence No. (REN)
...............................................(found on the rear of the unit)
A plug and jack used to connect this equipment to the
premises wiring and telephone network must comply with
the applicable FCC Part 68 rules and requirements adopted
by the ACTA. A compliant telephone cord and modular plug
is provided with this product. It is designed to be connected
to a compatible modular jack that is also compliant.
The REN is used to determine the number of devices that
may be connected to a telephone line.
Excessive RENs on a telephone line may result in the
devices not ringing in response to an incoming call. In most
but not all areas, the sum of RENs should not exceed five
(5.0). To be certain of the number of devices that may be
connected to a line, as determined by the total RENs,
contact the local telephone company. For products approved
after July 23,2001,the REN for this product is part of the
product identifier that has the format US:AAAEQ##TXXXX.
The digits represented by ## are the REN without a decimal
point (e.g.,03 is a REN of 0.3).
If this equipment causes harm to the telephone network, the
telephone company will notify you in advance that temporary
discontinuance of service may be required. But if advance
notice isn't practical, the telephone company will notify the
customer as soon as possible. Also, you will be advised of
your right to file a complaint with the FCC if you believe it is
necessary.
The telephone company may make changes in its facilities,
equipment, operations or procedures that could affect the
operation of the equipment. If this happens the telephone
company will provide advance notice in order for you to
make necessary modifications to maintain uninterrupted
service.
If trouble is experienced with this equipment, for repair or
warranty information, please contact a Factory Servicenter
or other Authorized Servicer. If the equipment is causing
harm to the telephone network, the telephone company may
request that you disconnect the equipment until the problem
is resolved.
Connection to party line service is subject to state tariffs.
Contact the state public utility commission, public service
commission or corporation commission for information.
This equipment is hearing aid compatible as defined by the
FCC in 47 CFR Section 68.316.
If your home has specially wired alarm equipment connected
to the telephone line, ensure the installation of this
equipment does not disable your alarm equipment. If you
have questions about what will disable alarm equipment,
consult your telephone company or a qualified installer.
WHEN PROGRAMMING EMERGENCY NUMBERS
AND(OR) MAKING TEST CALLS TO EMERGENCY
NUMBERS:
1) Remain on the line and briefly explain to the dispatcher
the reason for the call.
2) Perform such activities in the off-peak hours, such as
early morning or late evenings.
CAUTION:
To assure continued compliance, use only shielded parallel
or USB interface cable when connecting this equipment to
host computer. Also, any changes or modifications not
expressly approved by the party responsible for compliance
could void the user’s authority to operate this equipment.
Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate this device.
NOTE:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and
receiver.
— Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician
for help.
Responsible Party:
Matsushita Electric Corporation of America
One Panasonic Way, Secaucus, NJ 07094
Technical Support:
Panasonic Consumer Electronics Company Division of
Matsushita Electric Corporation of America
One Panasonic Way, Secaucus, NJ 07094
Telephone: 1-800-HELP-FAX (1-800-435-7329)
KX-FLB756 (080-085) 03.5.13 2:05 PM Page 81