Panasonic CU-E12GKE - Manual (Page 4)

4
0!42/,
3%.3/2
• In heat mode, it takes a while for the unit to warm up. The
power indicator blinks during this operation.
HOW TO OPERATE
Remote
control
display
REMOTE CONTROL TRANSMITTER
AUTO MODE - FOR YOUR CONVENIENCE
HEAT MODE - TO ENJOY WARM AIR
• Make sure it is not
obstructed.
• Certain fl uorescent lights
may interfere with signal
transmission. Please
consult your nearest
dealer.
Maximum distances : 8m
RECEIVER RECEIVER RECEIVER RECEIVER
Close
Insert AAA or
R03 batteries
Pull out
Inserting the batteries
• The batteries can be used for approximately 1 year.
Replace the batteries when the remote control display or
transmission signal becomes weak.
Setting the current time
Select Turn on Adjust
temperature
Set time
Confi rm
Press
REMOTE CONTROL PREPARATION REMOTE CONTROL PREPARATION REMOTE CONTROL PREPARATION REMOTE CONTROL PREPARATION
MODE OPERATION MODE OPERATION MODE OPERATION MODE OPERATION
AUTO HEAT
DRY COOL
INDICATOR INDICATOR INDICATOR INDICATOR
• Unit selects the operation mode according to temperature
setting, outdoor and room temperature.
• Operation mode is reselected every 30 minutes. During
operation mode selection the power indicator blinks.
Notes:
• Press RESET button to restore the remote control’s
default setting.
• For normal operation, the and RESET buttons are not
in use.
• While using remote control, please be aware of the OFF
indication on the remote control display to prevent the unit
from starting / stopping improperly.
• PATROL operates automatically once the unit is switched on
with button.
COOL MODE - TO ENJOY COOL AIR
• During soft dry operation, the indoor fan operates at low
fan speed to give a very gentle cooling operation.
● The range of temperature for selection is
16°C ~ 30°C.
● Operating the unit within the recommended
temperature could induce energy saving.
HEAT MODE : 20°C ~ 24°C.
COOL MODE : 26°C ~ 28°C.
DRY MODE : 1°C ~ 2°C lower than room temperature.
DRY MODE - TO DEHUMIDIFY THE
ENVIRONMENT