Pyramid Car Audio PB 610 SX - Manual (Page 13)

-12-
MECHANICAL INSTALLATION
PYRAMID SERIES
Mark the locations for the mounting screw holes by holding the AMPLI-
FIER in place and using a scribe or one of the mounting screws inserted in
each mounting hole in turn to mark the mounting surface. If the mounting
surface in carpeted, measure the hole centers and mark with a felt-tip pen.
Drill pilot holes for the mounting screws into the holes of the system insert
the mounting screws into the holes and tighten them securely.
*WARNING*
Investigate the layout of your automobile thoroughly before drill-
ing or cutting any holes. Take care when you work near the gas tanks,
lines, or hydraulic lines, and electrical wiring. Don't use power ampli-
fier unmounted. Attach this system securely to the automobile to pre-
vent damage, particularly in the event of an accident.
Don't mount this system so that the wire connections are unpro-
tected or are subject to pinching or damage from nearby objects.
The +12VDC power wire must be fused at the battery positive termi-
nal connection. Before making or breaking power connections at this
system power terminals, disconnect the +12V wire at the battery end.
Confirm your radio/cassette player and/or other equip is turned off
while connecting the input jacks and speaker terminals.
If you need to replace the power fuse, replace it only with a fuse
identical to that supplied with the system. Using a fuse of different type
or rating may result in damage to this system which isn't covered by
the warranty.