Panasonic BT-3DL2550E - Manual (Page 30)

30
Main Menu
(continued)
*1 These functions are not available when “RGB-COMP.” under “YP
B
P
R
/RGB” or “DVI-COMP.” under “DVI-D” is
selected in the “INPUT SELECT” menu (J page 40).
*2 To use the “TWO WINDOW” (J page 44) function,
1) Change settings after exiting the “TWO WINDOW” function.
2) It is recommended to use “MODE2” for handling fast video.
*3 “SCAN” changes are not reflected in Anamo size display.
Sub menu Setting Description
SHARPNESS H *1 0 - 30 Sets horizontal outline correction. The item display moves to the lower
part of the screen during adjustment. Both the main window and sub-
window can be set up in the split-screen display of the “TWO
WINDOW” function.
SHARPNESS V
*1
0 - 30 Sets vertical outline correction. The item display moves to the lower
part of the screen during adjustment. Both the main window and sub-
window can be set up in the split-screen display of the “TWO
WINDOW” function.
I-P MODE *1*2 MODE2
MODE1
Selects IP conversion mode. (J page 30, “IP mode”) Both the main
window and sub-window can be set up in the split-screen display of
the “TWO WINDOW” function.
<MODE2> Inter-field interpolation
<MODE1> Inter-frame interpolation
MONO *1 OFF
ON
Switches between color and monochrome (MONO).
<OFF> Color
<ON> Monochrome
• When ON, the CHROMA setting of the picture/volume adjusting menu
is fixed at 0.
ANAMO *1*3 OFF
ON
With an Anamo lens and HD-SDI input, the picture is resized to
Anamo magnification (the vertically enlarged signal can be vertically
compressed and corrected for display). Can be set in the split screen
display of the “TWO WINDOW” function, but operation is disabled.
SD ASPECT *1 4:3
16:9
Sets the aspect ratio for SD signal input. Can be set in the split screen
display of the “TWO WINDOW” function, but operation is disabled.
<4:3> 4:3 display
<16:9> 16:9 display
SCAN *1 NORMAL
UNDER
Sets under-scan and normal display. Can be set in the split screen
display of the “TWO WINDOW” function, but operation is disabled.
<NORMAL> Normal display
<UNDER> Under-scan
COLOR GAIN R 0 - 30 This fine tunes the GAIN of the R component. The R component of the
sub-window can be set in the split-screen display and sub-window
display (single screen) of the “TWO WINDOW” function in 2D mode. In
3D mode (COMPARISON), the R component of SDI2 (R) can be set.
COLOR GAIN B 0 - 30 This fine tunes the GAIN of the B component. The B component of the
sub-window can be set in the split-screen display and sub-window
display (single screen) of the “TWO WINDOW” function in 2D mode. In
3D mode (COMPARISON), the B component of SDI2 (R) can be set.
2D ONLY
2D ONLY
2D ONLY
2D ONLY
2D ONLY
IP mode
“MODE1” performs IP conversion using inter-frame interpolation.
The factory default is “MODE1”.
“MODE2” performs IP conversion using inter-field interpolation.
Since interpolation is performed inside each field, this mode is suitable for checking interlace status.
BT-3DL2550PE(VQT2U10)_E.book 30 ページ ２０１０年７月８日 木曜日 午後２時１２分