Panasonic BT-3DL2550E - Manual (Page 14)

14
Controls and Their Functions
(continued)
SDI terminal (BNC) *1*2
IN1 : This is the SDI input terminal (compatible with HD/SD automatic switching).
• In 3D mode with simultaneous double input (SIMUL), this is the L input terminal.
IN2
: This is the SDI input terminal (compatible with HD/SD automatic switching).
• In 3D mode with simultaneous double input (SIMUL), this is the R input terminal.
OUT1 : SDI output terminal (active through output)
• Output (active through) is available when the “SDI1” and “SDI2” options in the “INPUT SELECT” menu are
set to “ON”, and “SDI1” or “SDI2” is selected via the INPUT button.
OUT2 : SDI output terminal (active through output)
• Output (active through) is available when the “SDI1” and “SDI2” options in the “INPUT SELECT” menu are
set to “ON”, and “SDI1” or “SDI2” is selected via the INPUT button.
DVI-D terminal (DVI-D) *3
An HDCP compliant DVI-D signal input terminal.
VIDEO terminal (BNC) *4
IN : This is the VIDEO signal (analog composite signal) input terminal.
OUT : This is the input signal through-out terminal.
AUDIO IN terminal (pin jack)
This is the common audio input terminal for all video input terminals.
• Audio from SDI input is selected automatically when the “SDI1” and “SDI2” options in the “INPUT SELECT”
menu are set to “ON”, and the “INPUT SELECT” option of the “AUDIO” menu is set to “AUTO”.
Y/G, P
B
/B, P
R
/R terminal (BNC) *4*5
IN : This is the YP
B
P
R
/RGB signal input terminal.
OUT : This is the input signal through-out terminal.
SYNC/HD, VD terminal (BNC)
*6
IN : This is the input terminal for external synchronizing SYNC/HD, VD signals.
OUT : This is the input signal through-out terminal.
• When using RGB signals from a PC, connect the horizontal synchronizing signal to the SYNC/HD terminal,
and the vertical synchronizing signal to the VD terminal.
*1 Use double-sealed type cables for connecting to SDI input/output terminals.
*2 When inputting 3D image signals, ensure that left and right signals are input into the correct terminal.
*3 Use a DVI cable with a ferrite core.
*4 Unless a cable is connected to the OUT terminal, the IN terminal is automatically terminated at 75
Ω.
Since a connection to the OUT terminal releases the 75 Ω termination of the unit, the level of the VIDEO signal input to the
unit may become too large depending on the connected device.
*5 When a device is connected to the OUT terminal, 1080p and PC input and other broadband signals may distort character
outlines and other details.
*6 Unless a cable is connected to the OUT terminal, the IN terminal is automatically terminated at 1 k Ω. Making a connection to
the OUT terminal will automatically release the 1 k Ω termination.
Rear panel terminals
12 13 15 16 14 11
11
12
13
14
15
16
BT-3DL2550PE(VQT2U10)_E.book 14 ページ ２０１０年７月８日 木曜日 午後２時１２分