Panasonic BT-3DL2550E - Manual (Page 40)

40
Main Menu
(continued)
Underlined values indicate factory defaults.
*1 All five input lines (VIDEO, SDI1, SDI2, YP
B
P
R
/RGB, DVI-D) cannot be turned off. An attempt to turn off all
inputs ends when the fourth input line is turned off since it will not be possible to turn off the 5th input line also.
*2 “AUTO” is the factory default, but select a specific format when there is risk that the input signal may be
contaminated by outside noise.
*3 When 3D mode is set to SIMUL, the SDI1 and SDI2 lines are selected regardless of the OFF/ON setting.
INPUT SELECT
Sub menu Settings Description
VIDEO OFF
ON Turns VIDEO line to the INPUT button on/off. *1
FORMAT AUTO
NTSC
PAL Selects the video input format. *2
<AUTO> Automatically selects NTSC or PAL.
<NTSC> NTSC
<PAL> PAL
NTSC SETUP 75
00 Selects NTSC setup level.
<75>
Select this function when using 7.5% setup signals.
(Adjusts the interior of the monitor to the 7.5% setup
level to suit the black level)
<00> Select this when there is no setup signal.
SDI1 *3 OFF
ON Turns SDI1 line to the INPUT button on/off. *1
SDI2 *3 OFF
ON Turns SDI2 line to the INPUT button on/off. *1
YP
B
P
R
/RGB OFF
ON Turns YP
B
P
R
/RGB line to the INPUT button on/off. *1
MODE YP
B
P
R
RGB-VIDEO
RGB-COMP.
Selects YP
B
P
R
(component) or RGB input mode.
<YP
B
P
R
> Selects the YP
B
P
R
signal.
<RGB-VIDEO> Selects the video RGB signal.
<RGB-COMP.> Selects the PC RGB signal.
COMPONENT
LEVEL SMPTE
B75
B00 Selects YP
B
P
R
(component) signal input level.
<SMPTE> Signal level complies with SMPTE and P
B
and P
R
are
0.7 V [p-p] at 100% chroma.
<B75> Select this when connecting a Betacam or similar
device with a setup function. (Adjusts the interior of the
monitor to the 7.5% setup level to suit the black level)
<B00> Select this when connecting a Betacam or similar
device without a setup function.
SELECT SYNC INT
EXT Selects the sync signal when using YP
B
P
R
and RGB-VIDEO input.
<INT> Select when the synchronizing signal is superimposed
on the G or Y signal.
<EXT> Select to synchronize with an external synchronizing
signal.
COMP. Performs analog PC settings. (“COMP.” J page 41)
DVI-D *3 OFF
ON Turns DVI-D line to the INPUT button on/off. *1
MODE DVI-VIDEO
DVI-COMP. Selects DVI-D input mode.
<DVI-VIDEO> Selects the RGB signal input of RGB video.
<DVI-COMP.> Selects PC input.
2D ONLY
2D ONLY
2D ONLY
2D ONLY
2D ONLY
2D ONLY
2D ONLY
2D ONLY
BT-3DL2550PE(VQT2U10)_E.book 40 ページ ２０１０年７月８日 木曜日 午後２時１２分