Printronix T4204 - Manual (Page 132)

132
Chapter 3 LinePrinter Plus Emulation
LinePrinter Plus P-Series Emulation
Control Code 06
Control Code 06 defines the function of ASCII code hex 06 (ACK). You can
select an alternate line spacing of 6, 8 or 10.3 LPI.
Control Code 08
Control Code 08 defines the function of ASCII code hex 08 (BS). You can
define the code to output an elongated character or a backspace.
Define CR Code
This option controls the action of the printer when it receives a Carriage
Return code (hex 0D) from the host computer. If this feature is enabled, each
time the printer receives a Carriage Return, it inserts an additional Line Feed
code (hex 0A) into the data stream. Do not use this feature if the host
computer sends Line Feeds to the printer.
• CR = CR. Does not insert an extra Line Feed after each Carriage Return.
• CR = CR + LF. Inserts an extra Line Feed after each Carriage Return.
The next print position will be print position 1 of the next line.
Printer
Protocol
(from page 125)
Control Code
06
Control Code
08
Define CR
Code
Auto LF Overstrike Define LF
Code
Select SFCC EVFU Select Alt. Set 80-9F Character Set
6.0 LPI
8.0 LPI*
10.3 LPI Elongated*
Backspace CR = CR*
CR = CR + LF Disable*
Enable Enable*
Disable LF = CR + LF*
LF = LF
1*
(0-7F hex) Enable*
Disable Control Code*
Printable (see page 135)
* = Factory Default
P-Series
SFCC d
Command
PSeries
Dbl High
Even dot plot*
Double high Normal *
P3/4/6/9 Compat
FF Valid at
TOF
Enable*
Disable