Printronix T4204 - Manual (Page 70)

70
Chapter 3 Menu Options
Alarm
• On. An audible alarm sounds (3 beeps) when a fault occurs, such as a
paper jam.
• Continuous. A continuous audible alarm sounds when a fault occurs,
which can be stopped by pressing CLEAR.
• Off. No audible alarm will sound.
Power-Up State
• Online. The printer powers up in the online state.
• Offline. The printer powers up in the offline state.
Hex Dump Mode
A hex code printout (or hex dump) translates all incoming data to hexadecimal
equivalents. A hex dump lists each ASCII data character received from the
host computer, together with its corresponding two-digit hexadecimal code.
Hex dumps can be used to troubleshoot some types of printer data reception
problems. Hex Dump Mode is supported with a minimum media width of 4.10
inches.
NOTE: Narrower media will result in characters missing or truncated in the
printout.
PTX SETUP Option
Selects the Special Function Control Code for the PTX SETUP command and
functions.
• Setup Parse. Disables or enables the PTX SETUP command.
• Setup SFCC. Allows you to choose the hex value of the ASCII character
you wish to use as the SFCC for the PTX SETUP command. Valid hex
values are 01-FF. The default value is hex 21, which corresponds to the
“!” character.
Display Language
This parameter chooses the language that will appear on the LCD: English,
Spanish, French, Italian, or German.
Reset Cmd CFG Ld
When the printer receives a host data stream reset command (ESC @ or
ESC[K) in addition to resetting printer variables, the selected configuration will
be loaded.
• Disable. The active emulation parameters are loaded when the reset
command is executed.
• Power-Up Config. The power-up configuration is loaded when the reset
command is executed.