Panasonic KX-FL611 - Manual (Page 53)

7. Programmable Features
51
1. Press {MENU}.
2. Press {#}, then {4}{1}.
3. Press {A} or {B} repeatedly to select “ ON”.
4. Press {SET}.
5. Enter your code from 2 to 4 digits, using 0–9,
{*} and {#}.
L The default code is “; #9”.
L Do not enter “0000”.
6. Press {SET}.
7. Press {MENU}.
Code #44: Setting the memory reception alert
RECEIVE ALERT
MODE=ON [ ±]
To alert you with a beeping sound when a
received fax document is stored into memory
due to some existing problem.
The slow beeps will continue until you clear the
printing problem and make sure the unit is
supplied with enough paper to print the stored
document.
“
ON” (default): You will be alerted to a reception
problem by a beeping sound.
“
OFF”: Deactivates this feature.
Code #46: Setting friendly reception
FRIENDLY RCV
MODE=ON [ ±]
To receive a fax automatically when you answer
a call and hear a fax calling tone (slow beep).
“
ON” (default): You do not have to press {FAX
START} for fax reception.
“
OFF”: You have to press {FAX START} for fax
reception.
Code #68: Setting the Error Correction Mode
(ECM)
ECM SELECTION
MODE=ON [ ±]
This feature is available when the
transmitting/receiving fax machines are ECM
compatible.
“
ON” (default): To send a fax even if there is
static interference on the telephone line.
“
OFF”: Deactivates this feature.
Code #76: Setting the connecting tone
CONNECTING TONE
MODE=ON [ ±]
If you often have trouble when sending faxes,
this feature allows you to hear connecting tones:
fax tone, ring back tone and busy tone. You can
use these tones to confirm the status of the other
party’s machine.
“
ON” (default): You will hear connecting tones.
“ OFF”: Deactivates this feature.
L If the ring back tone continues, the other
party’s machine may not be a fax machine or
may have run out of paper. Check with the
other party.
L The connecting tone volume cannot be
adjusted.
Code #79: Setting toner save feature
TONER SAVE
MODE=OFF [ ±]
“ ON”: The toner cartridge will last longer.
“ OFF” (default): Deactivates this feature.
Note:
L This feature may lower the print quality by
reducing toner consumption.
Code #80: Resetting advanced features to
their default settings
SET DEFAULT
RESET=NO [ ±]
To reset the advanced features:
1. Press {MENU}.
2. Press {#}, then {8}{0}.
3. Press {A} or {B} repeatedly to select “ YES”.
4. Press {SET}.
5. Press {SET} again.
6. Press {MENU}.
FL611-PFQX2072ZA-en.book Page 51 Thursday, December 21, 2006 11:10 AM