Paxar Monarch 9805 - Manual (Page 5)

L o a d i n g L a b e l s
Thermal Direct Supplies that do not require a ribbon for printing.
Thermal Transfer Supplies require a ribbon for printing. Some
models may not support thermal transfer printing.
If you are using thermal direct supplies, do not load a ribbon. Make sure
the printer is configured for the correct supply type. If you experience
supply feeding problems with 2.0-inch wide or less supplies, adjust the
wide/narrow knobs to the wide setting. You may also need to use the
wide setting in cold, dry environments.
1. Open the cover.
2. Unlock the printhead by turning the
retaining latch.
3. Lift printhead assembly using the
printhead tab until the assembly
locks into place.
4. Center the roll of supply on the
supply holder. Make sure the
supply unrolls from the top as
shown.
If you are using fan-fold
supplies, place the supply stack
behind the printer, label side facing
up.
5. Push down on the supply lever to
unlock the supply guides.
6. Lay the label strip across the
supply guide so that a few inches
extend past the front of the printer.
Tuck the supply under the nibs.
Supply Holder
Printhead Tab
Roll Supply
Fan-Fold Supply
3